ElectricalMedium
Battery drain from short trips and failing alternator
- Typically appears
- Age-related
- What to inspect
- Cold-crank test and check charging voltage
2025 Hyundai i10 problems
A 2025 Hyundai i10 is now a year old, so an average example has covered around 13,500 miles. The final model year of the generation · generally the most sorted build, so mileage, servicing and condition matter more than build-year faults. Check the state safety inspection and service history alongside the documented faults below, which are sorted by whether a 2025 car has usually reached the mileage where they appear.
Compiled & reviewed by the VehicleFaults Research Team
Quick answer
The 2025 Hyundai i10 is a year old, so an average example has covered roughly 13,500 miles. At that mileage most documented faults are still ahead of it, so servicing evidence matters more than wear. A further 6 typically appear later in the car's life.
Turn these known faults into a step-by-step viewing plan for this exact Hyundai i10 · $9.
Build the inspection planFaults that appear at any mileage
Age, electronics and build-related issues that are not mileage-driven.
BodyworkLow
Door edge and tailgate corrosion on older cars
- Typically appears
- 8+ years
- What to inspect
- Inspect edges and the tailgate seam
Faults still ahead of this car
Typically appear later than this year's average mileage · worth budgeting for rather than inspecting.
TransmissionMedium
Clutch wear from town driving and learner use
- Typically appears
- 50,000+ miles
- What to inspect
- Check bite point and hill-hold
SuspensionMedium
Rear beam and shock wear from potholes
- Typically appears
- 70,000+ miles
- What to inspect
- Bounce test the rear and inspect for corrosion
EngineHigh
Timing chain rattle and stretch caused by neglected oil changes on Kappa engines.
- Typically appears
- 50,000-80,000 miles
- What to inspect
- Cold start the engine with the bonnet open. Listen for a sharp metallic rattle from the right side of the engine block that lasts longer than two seconds.
BrakesMedium
Seized rear brake calipers or sticking handbrake mechanisms from light town use.
- Typically appears
- 4-6 years or 40,000 miles
- What to inspect
- Apply and release the handbrake, then push the car on a flat surface to check for binding. Listen for a continuous grinding noise from the rear when moving.
InteriorLow
Heater blower motor only functioning on the highest setting due to a blown resistor.
- Typically appears
- 30,000-60,000 miles
- What to inspect
- Turn the ignition on and cycle the interior heater fan through speeds 1, 2, 3, and 4. Ensure air blows consistently on all settings, not just maximum.
SteeringMedium
Knocking noise from the steering column due to a worn EPS flexible motor coupling.
- Typically appears
- 60,000-90,000 miles
- What to inspect
- With the engine running and stationary, rock the steering wheel quickly left and right by a few inches. Listen for a distinct clunk from behind the steering wheel.
Inspecting a 2025 Hyundai i10?
Turn this car's known weak points into a step-by-step viewing plan · what to inspect, what a bad result means and what to ask the seller.
Build my inspection planHyundai i10 · frequently asked questions
Is the i10 a safe retail car?
Yes, it is one of the lowest-risk small cars for UK dealers.
What is the main check?
Clutch condition plus battery health if the car has stood on the forecourt.
Automatic or manual?
The automated manual is slow but reliable; manuals retail faster.
What is the timing belt replacement interval?
Both the 1.0-litre and 1.2-litre Kappa engines utilise a timing chain rather than a cambelt. These are designed to last the lifetime of the vehicle and do not have a set replacement interval. However, they are highly sensitive to oil degradation, making a complete service history essential to prevent premature chain stretch.
Are there any specific issues with the infotainment screens on Mk3 models?
The 8-inch touchscreen on Mk3 models from 2020 onwards can occasionally freeze, reboot randomly, or drop Apple CarPlay and Android Auto connections. This is usually resolved by a software update via the Hyundai dealer network, but you should test all screen functions and USB ports during appraisal to ensure hardware is operational.
Does the 1.0-litre engine consume excessive oil?
The 1.0-litre three-cylinder engine is generally robust but can suffer from increased oil consumption if piston rings become gummed up from prolonged short-journey use. Check the dipstick for low levels or thick, sludgy oil, and inspect the exhaust tailpipe for heavy, oily soot deposits which indicate the engine is burning oil.
Other i10 model years
Buying a Hyundai i10? Build a step-by-step viewing plan for this exact car · $9.
Build the plan